On Mon, Oct 10, 2011 at 11:30 AM, Brandon Phelps <bphelps@gls.com> wrote:
> Hello all,
>
> I have written a script which stops postgres on my standby server, executes
> pg_start_backup on the master, rsync's the data directory and tablespaces
> over to the standby, executes pg_stop_backup on the master, and attempts to
> then start postgresql on the standby. My problem is the following error
> when I try to start postgresql on the standby:
>
> * Starting PostgreSQL 9.1 database server
> * The PostgreSQL server failed to start. Please check the log output:
> 2011-10-10 12:25:21 EDT LOG: database system was shut down at 2011-10-10
> 12:25:18 EDT
> 2011-10-10 12:25:21 EDT LOG: entering standby mode
> 2011-10-10 12:25:21 EDT LOG: streaming replication successfully connected
> to primary
> 2011-10-10 12:25:21 EDT LOG: incomplete startup packet
> 2011-10-10 12:25:21 EDT WARNING: WAL was generated with wal_level=minimal,
> data may be missing
> 2011-10-10 12:25:21 EDT HINT: This happens if you temporarily set
> wal_level=minimal without taking a new base backup.
> 2011-10-10 12:25:21 EDT FATAL: hot standby is not possible because
> wal_level was not set to "hot_standby" on the master server
> 2011-10-10 12:25:21 EDT HINT: Either set wal_level to "hot_standby" on the
> master, or turn off hot_standby here.
> 2011-10-10 12:25:21 EDT LOG: startup process (PID 20370) exited with exit
> code 1
> 2011-10-10 12:25:21 EDT LOG: aborting startup due to startup process
> failure
>
> I have tried running pg_resetxlog on both servers, and have verified that
> pg_hba.conf contains my replication user. I have also verified that the
> password I am supplying in my recovery.conf is correct.
>
> Any ideas why I would get this message? I know that wal_level = hot_standby
> on the master and the slave.
did you set that *before* setting up the standby or after? did you
remember to u-comment the line in postgresql.conf?
merlin
